Mokapots, Moka, or Stovetop Espresso, Period.

[md4958]

Originally Posted by tzaddi

This Just In!!
Mokapot Goes Main Stream.

Thats a great price on the Brikka!

Originally Posted by Mister Moo

I don't really know how important the "no soap" admonition really is. That could be more conventional wisdom which is just silly, like the "never let french press coffee sit or it'll go bitter" (it doesn't).

The chatter sez that there is some kind of metallic flavor with new aluminum pots that goes away after you use them for a while (and don't soap them clean). Theory is that coffee oils lingering in the upper pot seal the aluminum and protect coffee flavor. Maybe it does and maybe it doesn't. (shrug-shrug)


As for me, I rinse lower, filter and upper with hot water after use. If I can see any grunge hanging on after a hot rinse I'll wipe them "clean" with a paper towel. Oils remain? Sure.

If the upper pot or filter start to look grungy (not too often) or smell anything except good (not too often) then I wash the whole shooting match with hot water, soap and a soft dishcloth or sponge (nothing that would scratch or scour the metal finish). Oils remain? No, except inside the centerpost. Taste suddenly suffers? I think not.

Your sense of taste may say otherwise.

Dish soap MAY affect the taste because it leaves a residue and cuts the oils (basically it does what its supposed to do). At my shops we NEVER use dish soap on any of our coffee pots, or porta-filters. We use a coffee soap called PuroCaffe wich will not leave any residue and gets all the build up off with little or no scrubbing. We always re-season the portafilters by pulling a couple shots of espresso on each group first.

The moka pots do need seasoning... the more you use it the better it tastes (like a cast-iron skillet). I usually tell my customers buying mokas that they should brew and toss the first two or three pots of coffee.

That being said, my mother has used dish soap on her moka for years and years with no second thought. As Moo stated above dont use any abrasive cleansers (SOS, Softscrub, etc) on your mokapot.

You shouldnt put them in the dishwasher however.

[chris45set]

OK, the cigars weren't enough of an obsession / drain on the budget.
Last night I bought the Moka pot pictured above from Target (it is NOT a Brikka, but a 6 cup Moka).
Just brewed the first pot with whatever beans we have in the kitchen, using a whirly-blade grinder (it's the only one I currently have, taking baby steps here).
Sipping on it now, and while I understand this is the first batch out of a new device, it's very interesting to note the difference between the Moka coffee and the coffee from the Capresso brewer I usually drink (same beans, same grinder).
This brew is better than anything I managed to get out of the French Press I had years ago, this could get very interesting.
There is some underlying bitterness, but there is also a whole new palette of flavors at work here.
I do have one question, I pulled the pot off of the heat as soon as the flow of coffee changed from liquid to foam, as I didn't want to overcook it. Should I have left it for a bit longer, to let it develop its own "spume"?
It is still too hot to open to see how much water is left in the "little tank".
The top section filled to within less than an inch of the top, so I know I was getting close.
I also tried to not over apply the heat, started with the electric stove burner on Med, and dialed down just slightly when the coffee began to flow.
I know I am asking a pile of questions, but I am still new to this process.
Thanks for indulging my ignorance, and I look forward to what this little beastie can produce once it "cures".

Chris

[Mister Moo]

Originally Posted by chris45set

OK, the cigars weren't enough of an obsession / drain on the budget.
Last night I bought the Moka pot pictured above from Target (it is NOT a Brikka, but a 6 cup Moka).
Just brewed the first pot with whatever beans we have in the kitchen, using a whirly-blade grinder (it's the only one I currently have, taking baby steps here).
Sipping on it now, and while I understand this is the first batch out of a new device, it's very interesting to note the difference between the Moka coffee and the coffee from the Capresso brewer I usually drink (same beans, same grinder).
This brew is better than anything I managed to get out of the French Press I had years ago, this could get very interesting.
There is some underlying bitterness, but there is also a whole new palette of flavors at work here.
I do have one question, I pulled the pot off of the heat as soon as the flow of coffee changed from liquid to foam, as I didn't want to overcook it. Should I have left it for a bit longer, to let it develop its own "spume"?
It is still too hot to open to see how much water is left in the "little tank".
The top section filled to within less than an inch of the top, so I know I was getting close.
I also tried to not over apply the heat, started with the electric stove burner on Med, and dialed down just slightly when the coffee began to flow.
I know I am asking a pile of questions, but I am still new to this process.
Thanks for indulging my ignorance, and I look forward to what this little beastie can produce once it "cures".

Chris

Post #1, item #2 clearly states:

"Requirements:
a mokapot - smaller ones (1-3 cup) are the way to go. The big ones seem like a good idea but they are not. A one-cupper is very cool; two-cupper most useful; three-cupper for one hophead ex-crack addict or, perhaps, a normal married couple couple."

Six cuppers present their own special challenges, the least of which is, "Where will all the coffee come from and who is going to drink all that moka?" They're a bit harder to pack correctly because of the volume. If you're already happy given the that you're using a whirleyblade then you are going to be downright orgasmic when you get some med-fine burr-ground stuff in that brewer.

As far as heat and brewing, you'll have a hard time gauging the brew from a large pot with a whirleyblade. When you get some burr-ground just try to keep the brew moving slowly and steady according to heat on/heat off - aim for about 45-seconds to brew the pot from first drool to the moment brew starts to run clear.

I hope you get a lot of pleasure from the new mokapot.

New update:

As I sit here chomping my steel cut oats (thanks for that again Moo) I am sipping sweet Moka from my new 2 cup mokapot (Moe has reached god-like status to me now). I got a beautiful batch this morning. No burned smell or taste,check. Crema,check. The perfect amount for me to drink by myself,check(my old pot was a 6 cupper and now I think I will live longer now that I am not drinking the whole pot myself). This cigar forum is so awesome because now I have cigars, moka and steel cut oats. And my new espresso machine is set to arrive today. We will see what the day holds!! Thanks again guys

[Mister Moo]

Originally Posted by TRicker

New update:

As I sit here chomping my steel cut oats (thanks for that again Moo) I am sipping sweet Moka from my new 2 cup mokapot (Moe has reached god-like status to me now). I got a beautiful batch this morning. No burned smell or taste,check. Crema,check. The perfect amount for me to drink by myself,check(my old pot was a 6 cupper and now I think I will live longer now that I am not drinking the whole pot myself). This cigar forum is so awesome because now I have cigars, moka and steel cut oats. And my new espresso machine is set to arrive today. We will see what the day holds!! Thanks again guys

We will cover crispy, thick bacon in another thread.

[md4958]

Originally Posted by Mister Moo

We will cover crispy, thick bacon in another thread.

mmmm.... Bacon

Originally Posted by md4958

mmmm.... Bacon

haha was just about to post that but you beat me too it.

[Mister Moo]

Originally Posted by TRicker

...I am sipping sweet Moka from my new 2 cup mokapot... The perfect amount for me to drink by myself,check(my old pot was a 6 cupper and now I think I will live longer...

Here, above, it is explained why big mokapots are not for most people. The little whippers make plenty enough coffee for most moka drinkers. The big pots are for crowds and, by and large, it's still hard to find a crowd of moka drinkers in most of our houses.

If I ever drank a six-cup pot of moka they would find my remains orbiting Jupiter. GermantownRob, contrary to laws of normal human physiology, can drink enough moka to kill a horse and then enjoy a cigar. Except for Icelandic fishermen, Rob is the only exception I know to the "small pot saves lives" rule.

[DavenportESQ]

Do you have to use expresso, or can you use any coffee?

[muziq]

Originally Posted by DavenportESQ

Do you have to use expresso, or can you use any coffee?

Any coffee, just make sure the grind is right. It's part of the fun to experiment with not only different roasts, but mixes of roasts and beans of different origin. The difference in flavors can be striking, just the right kind of variety to keep you coming back year after year.