|
|
![]() |
#1 |
Guest
Posts: n/a
|
![]()
Thanks for the comments guys.
What would the reason be to not mix Active and Passive humidification systems? Maybe because they kindof work against each other (One humidifying, the other de-humidifying)? I was mostly thinking about doing something like set the Avallo to say 63% and have the beads at 65%. This way the Avallo prevents drops and the beads prevent spikes. Kindof like an HVAC system in the house keeping the temp between 65-70. AC kicks on if temp goes over 70, Heater kicks on if under 65. Any suggestions where to look for New/Used Thermoelectric units? I looked around a bit and found some suppliers, but it looks like there are all kinds of different systems out there. Not sure exactly what I need. ![]() |
![]() |
![]() |
#2 | |
Grrrrrr
![]() |
![]() Quote:
Just don't put the beads directly in the air output stream of the active humidifier or they'll end up saturated rather quickly, because the air stream itself from the active humidifier is at a very high humidity. Big problem you're going to probably have with the freezerdor is that it seals too well, so be careful with the active humidifiers - now, being in a desert at 4500ft, you might be ok due to the extreme dryness of the air. PM lou2row (he doesn't check in here that often) see if he has any advice, he converted a 20-something CF refrigerator to a humidor a few years ago, and AFAIK, it's been fine. |
|
![]() |
![]() |
![]() |
#3 | ||
Guest
Posts: n/a
|
![]() Quote:
Quote:
My biggest unknown overall is the cooling. The freezer insulation might help buffer against the daytime temps going above 80, the nights usually drop down to the 60's. It would give me great peace of mind to know for sure that my sticks can never go above 70 though. ![]() ![]() Thanks for the advice guys. |
||
![]() |