Cleaning a Blazer PB-207?

[chenvt]

Well thanks to the first post I was able to take my blazer apart and noticed what's wrong.. Basically, the top part is clogged somewhere.. Without the top, gas comes out fine.. but when it's on, nothing.. furthermore, when I take the top off after trying to get gas out, there's a gasp of butane that was trying to get out.. I'l see about getting some compressed air or something on the nozzle part to see if whatever is clogging it can be cleared up. Thanks again!

Originally Posted by Silound

The short answer is the most recent production runs have had flaky valves. I've had 2-3 go out that simply needed to be adjusted.


Use the post above to adjust your flame setting inside the lighter.

If you have issues with it, take it back to your local Blazer dealer, they should have some sort of repair/replace situation set up with Blazer.

[Silound]

Originally Posted by chenvt

Well thanks to the first post I was able to take my blazer apart and noticed what's wrong.. Basically, the top part is clogged somewhere.. Without the top, gas comes out fine.. but when it's on, nothing.. furthermore, when I take the top off after trying to get gas out, there's a gasp of butane that was trying to get out.. I'l see about getting some compressed air or something on the nozzle part to see if whatever is clogging it can be cleared up. Thanks again!

Ber very careful, there's a small fine fine fine mesh screen in there that can blow out (size of a pinhead). That's actually what gets clogged, so when you blow it out, at least make sure you blow it into a baggie or something so you don't lose the screen if it comes out.