Shilala's Perfect Frigidaire Wine Fridge How To

[G G]

Originally Posted by T.G

Yes, polarity matters since the fans are DC. Red wire is hot (+). If you hook it up backwards, it will either not run or you'll let the blue smoke out. If that happens, it'll never work.** If the fan has a yellow wire, you can ignore it, that's the feedback sensor for the RPM fan speed.

Assuming that each fan has the same nameplate data, 0.16A, that's 160mA each, that means for 3 fans, your draw will be around 480mA. In simple terms, equipment only draws the current (amperage) that it needs, so you can go higher, it won't hurt anything. I'd say go with at a 1A to 1.5A power supply would be fine and you can usually find them in thrift stores for about a buck. Depending on the fans, and I don't see it in the manufacturer literature for the ones you have, so I wouldn't do in your case without more research, you can run the fans at a lower voltage, like 9VDC to have them turn slower and not make as much noise.

So long as you maintain polarity, you can extend the wire by splicing in a longer section with crimp butt splices or just buy an extension that has the round plug ends (places like radio shack or fry's electronics have these).


**: Little known fact, electrical equipment doesn't actually run on electricity. It runs on a pre-installed charge of magic blue smoke. The electricity is necessary to create a field which keeps the blue smoke captive. If you let the blue smoke out, it won't run anymore.

I am certainly not an electrician, but I was thinking that the little picture on the back of the adaptors were something about polarity. It's probably the same thing you are saying, and it's good info whether I'm dumb or not. Thanks for adding that to the thread. I hope with my info, and others adding more, that someone can do one of these and just follow the thread and not have to ask ten thousand questions like I did. Thanks.

[T.G]

Originally Posted by G G

I am certainly not an electrician, but I was thinking that the little picture on the back of the adaptors were something about polarity. It's probably the same thing you are saying, and it's good info whether I'm dumb or not. Thanks for adding that to the thread. I hope with my info, and others adding more, that someone can do one of these and just follow the thread and not have to ask ten thousand questions like I did. Thanks.

Yes, the pictures are.

AC vs DC markings:


1A = 1000mA

Tip/Ring polarity markings - note how #1 and #4 are the same, as are #2 and #3 - sometimes they mark the symbols upside down on the power supplies. The important part is the center dot is the "tip" the outer "C" is the "ring".



When you have a barrel connector, the center is always "Tip" the outer sleeve is always "ring". In the photo below, the power supply should be marked with the first or fourth image from the photo above.