Folly's Tower - Reaching for the Moon - Humidor Build Thread

WaxingMoon · 11-11-2012, 02:23 PM

You should end up with something like this....

A few taps of the dead blow hammer..... you should get something like this....

Time for the real deal....

Since my panel is 11-1/4" and the piece of wenge that I'm joining to it is only 3/4", I needed to make sure the wenge was firmly in place behind the panel, and adjusted in there with the spacer block.

I used a couple of pieces of wood (not necessarily scrap) that was planed earlier to the same thickness as the wenge & sapele panel as both a spacer and a hold down for the 3/4" piece of wenge behind the sapele....

All systems go!

11-11-2012, 02:23 PM	#11
WaxingMoon Humidor Builder Join Date: Dec 2009 First Name: Ed Location: Albert Lea, MN Posts: 658 Trading: (3)	Re: Folly's Tower - Reaching for the Moon - Humidor Build Thread You should end up with something like this.... A few taps of the dead blow hammer..... you should get something like this.... Time for the real deal.... Since my panel is 11-1/4" and the piece of wenge that I'm joining to it is only 3/4", I needed to make sure the wenge was firmly in place behind the panel, and adjusted in there with the spacer block. I used a couple of pieces of wood (not necessarily scrap) that was planed earlier to the same thickness as the wenge & sapele panel as both a spacer and a hold down for the 3/4" piece of wenge behind the sapele.... All systems go! __________________ This correspondence has killed no trees, however, several electrons have been disturbed!

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode