Quote:
Originally Posted by kelmac07
And it's empty...just sayin.  |
i remember those constant threats about vinotemps being too empty!!
Make sure you get that drain plug covered if it hasn't already been done and also make sure you get some sort of run off thing going on the back wall on the inside of the vinotemp as well! Some go all out but to be honest, i just used some good quality packaging tape for the drain hole and 2 yrs later it still works.
As for the run off thing in the back, it'll look like a V but at the bottom of the V it won't be connected, its for moisture build up to collect back there and run down to the drain hole. I again ghetto rigg'ed mine with cardboard and the same packaging tape. I just cut cardboard to fit the slot perfectly then covered it with the tape and slapped it on, then i put a small tupaware full of beads for the moisture to run off into. Good luck with it!