WNY

Hey guys, got a question I'm sure has been covered before but if you would not mind answering it again for me that would be greatly appreciated.

Humador set up.

So I bought me a humador(50 count). Am in the process of setting it up by spraying the inside of it down with the distilled water. Once every 12 hours. This has been going on for 3 days now. i am noticing that the humador is hard as hell to open up now. I have to really pull on the top to get it opened up. Now I understand that this is simply the wood expanding to take in the water and that is fine. Today I woke up and went to check it to spray it down again but I did not as the humidity in there was at 75.

So here is the question.


Am I correct in doing the following:

I have not sprayed it down today due to the high humidity factor I found this morning. I am thinking maybe I leave the humador open a crack. Let the RH drop a bit and maybe give the wood a little time to breath and let the swelling go down a bit. I'm thinking keep a vigilant eye on it and when I notice the RH drop down to say 60 or 65 (hopefully the swelling has gone down) start the spray process again and bring the RH back up slowly. I think It swelled the way it did because I may have been over spraying the inside of it with water.

If the sticking is not even a problem at all that will eventually fix itself maybe this will not even be necessary, I can just leave the box closed and not add water again till I notice the RH drop to about 70 then see if it stabilizes at that for a couple of days.

I'm not trying to rush the process here I just want to do it right the first time before I go loading it up with cigars.

Thanks ahead of time guys I appreciate it.