Cigar Asylum Cigar Forum

Cigar Asylum Cigar Forum (http://www.cigarasylum.com/vb/index.php)
-   Accessory Discussion / Reviews (http://www.cigarasylum.com/vb/forumdisplay.php?f=14)
-   -   Mr Heater Buddy is sputtering (http://www.cigarasylum.com/vb/showthread.php?t=5315)

Jason 12-01-2008 10:42 PM

Mr Heater Buddy is sputtering
 
and I'm flippin cold

http://dsp.imageg.net/graphics/produ...70717p275w.jpg

I'm pretty sure this needs a cleaning but I've no idea how to safely go about it, anyone?

Symptoms, noisey like when your tank is going empty and even on high the heat output now seems less than the LOW setting used to be.

Cold smoking sucks!

taltos 12-02-2008 05:37 AM

Re: Mr Heater Buddy is sputtering
 
Depending on the temperature at your location, you could be seeing one of the negatives with propane, it hates to flow at lower temperatures. Not sure how low but I know that I have had problems with it in the northeast.

rsamos 12-02-2008 05:47 AM

Re: Mr Heater Buddy is sputtering
 
I doubt it's the cold. I've had 10 & 20 lb tanks sitting on the ice outside my fish house when it's as cold as -20 with no problems.

I use the same heater in the off the bottle-cooker configuration. This one here: http://www.buy.com/prod/mr-heater-mh...203529894.html

Only I use an 8 foot hose to the heater to a 20lb tank rather than a small disposable bottle. In 20 years of use there's been roughly zero issues with it. But if I had to make a first guess as to what's up with yours, I'd think a plugged orifice or a problem in the regulator.

http://www.propaneproducts.com/paulin-parts.html

jjirons69 12-02-2008 12:46 PM

Re: Mr Heater Buddy is sputtering
 
Take it off the tank and disassemble as best you can, careful not to lose any parts. Make sure all the orifices are clean and reassemble. They're not that complicated and it should come back around. All else fails, call the manufacturer.

tedrodgerscpa 12-02-2008 01:21 PM

Re: Mr Heater Buddy is sputtering
 
Spiders do love to spin cobwebs in the tubes of those things.

My guess is that some compressed air would do nicely to blow things out.

That, and I think new ones run $30ish...

I'm assuming you've been to the troubleshooting section of their website, but if not, here's a link.

http://www.mrheater.com/troubleshooting.asp?id=24

Good luck, and let us know what you found...

Ted

shilala 12-02-2008 03:02 PM

Re: Mr Heater Buddy is sputtering
 
Like Ted said, spiders fill up the venturi tube with spider webs.
You can blow it out with compressed air. Like Jamie said, it's easy to take apart.
I have the same thing and I believe the oricfice is behind the venturi tube, so it's unlikely it's plugged at all, but there could still be stuff laying on it.
I keep mine in it's box over the summer so it doesn't get hogged up. I'm using it right now. It's the only thing standing between me and sofaman freezing to death while we try to smoke our cigars. :)

Jason 12-02-2008 08:02 PM

Re: Mr Heater Buddy is sputtering
 
haha, just read your Oliva review and noticed one in there

I stopped by the office earlier and blew it out with air everywhere possible, if that doesn't work I'll tear into it tomorrow.

Thanks to one and all

BlackDog 12-02-2008 09:02 PM

Re: Mr Heater Buddy is sputtering
 
It may want a filter. Sometimes oil gets in the propane tank, and clogs up the tube. You can buy a filter from most hardware stores for about $10.


All times are GMT -6. The time now is 09:46 AM.

Powered by vBulletin® Version 3.7.4
Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.