Cigar Asylum Cigar Forum

Cigar Asylum Cigar Forum (http://www.cigarasylum.com/vb/index.php)
-   Discussion (http://www.cigarasylum.com/vb/forumdisplay.php?f=37)
-   -   Barling Pre-trans Stem Replacement (http://www.cigarasylum.com/vb/showthread.php?t=65586)

alfredo_buscatti 02-20-2014 09:02 PM

Barling Pre-trans Stem Replacement
 
I bought this pipe knowing I might have to get a stem replacement; as it turns out the tenon is short, and it does.

I bought it from Marty Pulvers, and on my telling him that I meant to get a 2nd tier (he has three) replacement from George Dubos, which is $50.00 or twice the normal charge, who is Precision Pipe Repair, he said that he'd just recommend a $25.00 first tier replacement, that I didn't need the 2nd. My thinking was that I wanted to experience what a fine handcut stem was like; all the pipe gurus who smoke artisan pipes are always touting stem work as one of the most important ingredients of a well-made high-grade. As I don't own any high-grades, my thinking was that this was about the only way I could evaluate the high-grade stem-touters.

But Mr. Dubos didn't answer either of my emails. Any of you have luck in getting him to engage? Also, I still think that my thinking about the 2nd tier stem is accurate. Any thoughts on this?

OnePyroTec 02-22-2014 11:02 AM

Re: Barling Pre-trans Stem Replacement
 
After two tries, I would move on to someone else. I have had quick replies & service from Norwood on several occasions and there are several others to pick from who can do custom cut stems as well.

You can take a pre-formed stem and re-work it to smoke as well as a custom cut stem, but it won't "LOOK" as nice. If you value your own time, then a custom cut stem is the way to go IMHO because you will be money ahead with a better looking stem. :2

Now if you want to get real creative, Steve Norse has some cumberland blanks he got in a couple weeks ago. All you need to do is either add a delrin tenon or cut a tenon, fit & sand. They are pre-drilled & shaped @ only $15 each.

Bruce 03-05-2014 09:08 PM

Re: Barling Pre-trans Stem Replacement
 
Try RonnieB at Nightowl Pipe Works. Does incredible work. I had a high grade S. Bang stem made by Ronnie after I broke the tenon and shattered the stem. I could not tell the difference. Plus he will custom tailor the bit to your preferences.
IMHO, better than George, and I had plenty of work done by George

gravel 03-05-2014 09:38 PM

Re: Barling Pre-trans Stem Replacement
 
Heya AB,

My understanding is George is easier to reach over the phone.


All times are GMT -6. The time now is 11:26 PM.

Powered by vBulletin® Version 3.7.4
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.