![]() |
Re: New Pipe Smoker With A Question? Ask an Old Fart
It's supposed to absorb tar and nicotine and to some degree it does...it also tapers down the whole draft hole business..som like it and some throw them away but if you do, realize you're going to have a very large draft hole running through most of the shank and stem...you can buy more of those if you want...Medico filters fit fine...
|
Re: New Pipe Smoker With A Question? Ask an Old Fart
Quote:
|
Re: New Pipe Smoker With A Question? Ask an Old Fart
Quote:
|
Re: New Pipe Smoker With A Question? Ask an Old Fart
Quote:
I also forgot to get pipe cleaners. And I'm using a 308 winchester case to tamp(don't worry, its been fired... And its fresh out of my case tumbler, so its clean)... And it also went out every time I went to tamp. I also burnt the hell out of the top of the bowl... Good thing the pipe only cost $4. I almost opted for the $20 one, but I kept all of your opinions in mind, and for those I thank you all :) -Jimmy PP |
Re: New Pipe Smoker With A Question? Ask an Old Fart
Quote:
Take some really light grit sandpaper and wrap it around your finger and then rub it around in there. Only do this enough to take off the coating. You definitely don't want to get too wild in there and shave it down too much! |
Re: New Pipe Smoker With A Question? Ask an Old Fart
Quote:
Having been where you are Jimmy, keep at it. It took me a few months, but I finally learned to load the pipe in such a way that it stays lit part of the time and only needs tamped a few times. And I got a eel for what kinds of tobacco work and don't. And well... the world just starts lining up for you :)... until then, keep at it, it doesn't take long to get there. I'll leave the wet aromatic tobacco bit and any other actual advice for an old fart to touch on, just wanted to give you a bit of encouragement that it will get much better fairly quickly. :D |
Re: New Pipe Smoker With A Question? Ask an Old Fart
Actually I haven't really been having too many problems. By the third bowl I had looked bowl packing up on youtube. And I found a way that works pretty good... I sprinkle tobacco into the bowl until full, tap the side to get it to settle down, then pinch tobacco in my fingers and set it on top, and coax it in by pushing on the sides, then repeat........ And the third time I smoked it didn't go out once. I did tamp it about every 5 minutes though. Who else does it like this?
I was smoking for at least half an hour, if not longer... I really didn't expect a tiny bowl to last that long! |
Re: New Pipe Smoker With A Question? Ask an Old Fart
Quote:
|
Re: New Pipe Smoker With A Question? Ask an Old Fart
Here's a question for ya fellas...
I have two Peterson Pipes, Donegal Rocky Style pipes with the sterling silver bands. What can I do to clean the silver up? They are starting to look a little dirty. |
Re: New Pipe Smoker With A Question? Ask an Old Fart
Wright's Silver Polish but use a q-tip to put it on and be careful you don't get any on the briar, although it probably wouldn't hurt the finish...I do it carefully and don't want to chance it anyway...
Wright's Silver Polish on ebay |
Re: New Pipe Smoker With A Question? Ask an Old Fart
Quote:
|
Re: New Pipe Smoker With A Question? Ask an Old Fart
Got a question. What is the best way to go about removing the gunk (tar I assume) left over in the very bottom of the bowl? I was just using the pick on my pipe tool, but feel like that may damage the pipe. Or maybe I'm just over concerned because it's a new pipe.
|
Re: New Pipe Smoker With A Question? Ask an Old Fart
got a question - I got a crapload of old pipes whose stems taste horrible. Plenty of ways to restore... whats the easiest?
|
Re: New Pipe Smoker With A Question? Ask an Old Fart
Quote:
|
Re: New Pipe Smoker With A Question? Ask an Old Fart
Quote:
If you’re talking about the moisture in the bottom of the bowl after smoking, leave it alone, you need it to form cake in the bottom of the bowl. Let the pipe cool after smoking before stirring the dottle and ash up from the bottom of the bowl, place your thumb over the top of the bowl and shake the pipe to coat the inside with the ash, then set it down and leave it alone for 1 or 2 days, 3 would be better. The next time you’re going to smoke the pipe, pass a pipecleaner through the stem into the bowl, making sure there aren’t any obstructions. Use a pipecleaner to gently remove any loose ash from the chamber walls, the “GUNK” from your last smoke will have absorbed into the dottle and ash you left in the bowl, this in turn forms the cake which will help to prevent the briar from burning. Quote:
|
Re: New Pipe Smoker With A Question? Ask an Old Fart
Quote:
Nasty on the outside vulcanite takes a little more effort. Which is it? |
Re: New Pipe Smoker With A Question? Ask an Old Fart
Quote:
|
Re: New Pipe Smoker With A Question? Ask an Old Fart
Another noob question.
Is there a site similar to the devil site for pipe tobacco? I want to try a big varity, and the B&M's here have a small selection of pipe tobacco around here. If there isnt, where would you suggest getting tobacco online? |
Re: New Pipe Smoker With A Question? Ask an Old Fart
pipesandcigars.com
smokingspipes.com 4noggins.com marscigars.com any of those will be a good place to find tobacco, unfortunately (by that I mean thank the Lord) there's no "pipebid" out there |
Re: New Pipe Smoker With A Question? Ask an Old Fart
Quote:
|
All times are GMT -6. The time now is 11:14 AM. |
Powered by vBulletin® Version 3.7.4
Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.