Log in

View Full Version : Public Service Announcement


BlackDog
11-30-2010, 09:02 PM
Having lock de-icer in your glove box is really useless.

That is all. :bh

MedicCook
11-30-2010, 09:16 PM
:r

Ogre
11-30-2010, 09:36 PM
Having lock de-icer in your glove box is really useless.

That is all. :bh

:sad

G G
11-30-2010, 09:39 PM
my locks never freeze.:tu

CigarNut
11-30-2010, 10:36 PM
It could have been worse -- you at a very remote vacation spot hundreds of miles from anywhere with your door locks frozen and the de-icer at home snug and warm in your garage... :)

T.G
11-30-2010, 10:45 PM
De-icer and locks huh? So, you mean there is a secondary use for that stuff besides spraying into blower scoops on dragsters and raceboats?

SmokeyJoe
11-30-2010, 10:51 PM
De-icer? Makes me feel embarrassed that it was 73 here today. :sh

Sorry for the troubles, bro. :ss

Bill86
11-30-2010, 11:29 PM
my locks never freeze.:tu

Same here. Even when I lived in Michigan my locks never froze.

icehog3
12-01-2010, 01:54 AM
Having lock de-icer in your glove box is really useless.

That is all. :bh

Pint of vodka is much more useful, Warren. ;)

DPD6030
12-01-2010, 02:34 AM
It could have been worse -- you at a very remote vacation spot hundreds of miles from anywhere with your door locks frozen and the de-icer at home snug and warm in your garage... :)

W/O a passport as well :r

maninblack
12-01-2010, 03:38 AM
Piss on the lock. And hurry up and open it before it re-freezes.

kelmac07
12-01-2010, 05:54 AM
:r :r :r

Conch Republican
12-01-2010, 05:57 AM
Pint of vodka is much more useful, Warren. ;)

Warming the locks from the inside - or to make you not care?

replicant_argent
12-01-2010, 06:23 AM
Then you find your door is frozen to the body.
Don you use the "pry your fingers into the frame" method, or the "Booty Bump"?

357
12-01-2010, 06:57 AM
Then you find your door is frozen to the body.
Don you use the "pry your fingers into the frame" method, or the "Booty Bump"?

I've lived in Michigan almost my whole life and I've never had my lock freeze. My wife's lock on her car did once, but it was because the little flap that covered the keyhole was broken and we got some freezing rain. This was on an older car that didn't have remote entry, or the fob was broke. Don't remember.

Anyway, I have had my doors freeze shut many times. Not sure why this happens but not the locks freezing?

icehog3
12-01-2010, 10:39 AM
Warming the locks from the inside - or to make you not care?

Yes. :)

BlackDog
12-01-2010, 11:09 AM
My wife's lock on her car did once, but it was because the little flap that covered the keyhole was broken and we got some freezing rain.
My truck is pretty new, but we had rain that later changed to snow, and the temps dropped to about 15 degrees. I'm guessing that either rain or condensation got into the lock and froze.

hscmit
12-01-2010, 12:08 PM
head south
problem solved

RevSmoke
12-01-2010, 12:09 PM
Ouch! Warren, I understand your pain.

When it gets too cold, I no longer use the car wash. When I see a coupel 32+ days in the forcast, then I get it done.

Peace of the Lord be with you.

replicant_argent
12-01-2010, 03:25 PM
Timely thread.....:c:bh


Went out today for a post office run......
Outer drivers door handle.... inoperative...


Crawled through the passenger door... pulled the handle....


Inoperative...


Bleh.
Found the solution.
Looks like about 1.5 hour job. (Yeah.... when it is warm out and your fingers aren't freezing) so I figure about 2.5 hours to disable the airbag, remove the door panel, get the lock assembly and door handle/cable assy apart, diagnose, THEN hopefully reassemble stuck/frozen parts rather than ordering a new carrier assembly....

Lovely weather we are having, si?

theoneandonly
12-01-2010, 04:53 PM
You could use a lighter to heat up the key to get it in the key hole and warm it that way. If you can't get the key in at all use the lighter to heat up the lock. Just make sure there is no plastic or rubber around it that could melt. You need to be careful when doing this. Growing up Northwest Indiana, I saw this trick/technique used and it worked. I was a little kid then but was still amazed and remember thinking I need to remember that trick.

357
12-02-2010, 06:55 AM
You could use a lighter to heat up the key to get it in the key hole and warm it that way. If you can't get the key in at all use the lighter to heat up the lock. Just make sure there is no plastic or rubber around it that could melt. You need to be careful when doing this. Growing up Northwest Indiana, I saw this trick/technique used and it worked. I was a little kid then but was still amazed and remember thinking I need to remember that trick.

Don't do this with a bic/zippo lighter. The fluid leaves gunk on the key which can gum up your lock. It can be cleaned out, but can be a pain.

Try WD-40 in the lock to keep water out. No water = No ice.

T.G
12-02-2010, 08:32 AM
Don't do this with a bic/zippo lighter. The fluid leaves gunk on the key which can gum up your lock. It can be cleaned out, but can be a pain.

Try WD-40 in the lock to keep water out. No water = No ice.

FWIW - Bic lighters are butane, not liquid lighter fluid ala Zippo.

the MacDonald
12-02-2010, 09:36 AM
I consider a frozen lock a clear message from God to stay the hell home.