9mm, 40 and 45 shell casing

[boom]

I am looking for a handful or so of brass shelling casing with primers already used left in place. I need these for a project for pipe smokers....I can pay postage or trade you a few sticks to compensate brass and postage.

Thanks in advance

Troy

[s15driftking]

hey brother,

I don't have any personally, but back about 3 years ago i was at an indoor range and they had garbage upon garbage cans full of smaller casings. give your local indoor range a call, they might even have larger ones.

[Nabinger16]

I can hook you up. Shoot me a pm with your address and how many you need. Brass or nickle plated? I think I can do both in all three calibers.

[skyhigh340]

I can also help if you need some pm me your addy and I'll send you some. also got 38, 44 and 45lc if you need it. No compensation needed. Let me know how much you want and I'll get it to ya.

[floydpink]

The guys at the range I go to use snow shovels to clear all the casings out of the lanes, so I'm sure I could also grab some if you need....

[boom]

Thanks guys I tried my local range and they don't even allow reloads to be used and on top of that they recycle all their brass.

[boom]

This is done mods pls closer up......

[boom]

Well after a skyhigh340 hooked it up here is what I used them for... Made a Pipe Tamper out of a 45 shell and some nice two-tone Cocobolo.... Thanks


http://i243.photobucket.com/albums/ff115/baseworks/DSCN2092.jpg

[Savor the Stick]

Nice!:dr

[alley00p]

Nice!:dr

:tpd: :tu

If you need any size from .22 up to .44 and .45LC let me know! :ss



:wo

[taltos]

I don't have any spare brass right now but you might like what you can do with some of the necked rifle cartridges such as 5.56 and 30-06.